Fiberpool. EU pool guarantee:

The pools are provided with 10-year warranty, if the pools are installed according to requirements of given instruction:
1. The fiberglass pool "Fiberpool.EU" has to be deepened into the ground for 135cm.
2. If the pool is not covered with polyurethane foam by factory, we recommend covering it with 30mm - thick sheets of polyurethane foam.
3. Exterior of the pool has to be filled with crushed stone, which layer has to be not thinner than 300mm from pool wall. Crushed stone - 8 - 32mm. 
4. The 5cm layer of fine gravel - crushed stone is required to even the surface.
5. Underneath the pool bottom there has to be 300mm dens pillow of crushed stone. Crushed stone 8 - 32mm.
When filling the external part of the pool, the pool has to be filled with water in parallel. During the filling procedure, the level of filled water has to be equal to the level of filled crushed stone; deviation - no more than 10cm.
The filling of hole starts at the ends of the pool - to ensure the stability of pool in the hole.
When filling the external part, watch the movement of the pool body at the widest point (to the outside or inside), possible deviation up to 5mm of home position.
When loading the pool into the hole, avoid any deformation of the pool body!
During the filling of exterior part with crushed stone, it is necessary to reinforce the body of the pool across with spokes.
Deepening scheme of the "Fiberpool.EU" pool:

Attention!

When groundwater is high, drainage is required under entire perimeter of the pool. 
If Client is not making a drainage system, Contractor is not responsible for damage, caused by groundwater.
During wintertime pool has to be left filled with water, with installed ice separation sheets in water.

Guarantee is not valid, if defects appear because of:
- Inappropriate care;
- Inappropriate exploitation; 
- If the pool was left empty during wintertime;

- Was build and installed not following the installation manual.